Post by @rotateabull@lemmy.ca

2026-11-15 03:48 UTC

Linux Mint Installation Issues on a Lenovo Yoga C930 I have attempted to install Mint 22.3 on my old laptop (Lenovo Yoga C930) which was previously running Windows 11 and seem to have no operating system present on the laptop now and can not boot from my USB drive. I started by downloading Mint 22.3 “Zena” on to a USB drive via Rufus, booted into Mint via the BiOS, and attempted to “Erase Disk and Install Linux Mint” by following the prompts. The install process gave some error messages as it proceeded and took significantly longer than the help videos I had watched beforehand suggested. I left it running over night and came back to it still attempting to install in the morning. I pressed the power button on the laptop to stop it and when I turned it back on was met with a message along the lines of “remove bootable drive”. The next message I got was “Default Boot Device Missing or Boot Failed”, I hit OK and now there appears to be no OS on the Boot Manager. When I put the bootable USB back in, the boot manager finds it but when I select it I receive: Failed to open \EFI\BOOT\mmx64.efi - Not Found Failed to load image (blank square): Not Found Failed to start MokManager: Not Found Something has gone seriously wrong: import_mok_state() failed: Not Found This is my first time attempting to install an operating system so I really am not sure what went wrong or where to go from here, any help would be greatly appreciated.

Replies (5)

@ShutUpWesley@piefed.zip 2026-11-15 03:51

What error messages did the installer give? It sounds like the installer image was corrupted… My shot-in-the-dark theory would be a bad USB drive.

Open ##5538374
@Skullgrid@lemmy.world 2026-11-15 04:12

you done goofed the secure boot stuff. github.com/hakuna-m/wubiuefi/wiki/MOKManager

Open ##5538438
@dan@upvote.au 2026-11-15 04:20

Try turning off secure boot in the BIOS. One possibility is that the USB is corrupted. Unfortunately, Rufus doesn’t verify that the data was copied to the USB properly. Try using balenaEtcher instead of Rufus, since (as far as I can remember) it has an option to verify that the write was successful.

Open ##5538462
@memo@piefed.zip 2026-11-15 07:57

As others pointed out, either: The image needs to be re-created onto the USB through balena or Rufus You have to browse around your BIOS options and disable SecureBoot (most probably) Make sure to look up your computer model and the button to press at boot to get into the BIOS, also referred by some computers as “boot into UEFI”

Open ##5539141
@thanksforallthefish@literature.cafe 2026-11-15 08:39

It feels to me like you’re only half reading the responses, so just to be sure: Your USB boot stick is possibly dodgy. Create a new one on a different machine, possibly using ventoy or balena rather than rufus (i recommend ventoy) Turn off secureboot in the bios (you were in boot manager) Boot the newly created usb boot disk after doing 2 Reinstall following the prompts (what is on your laptop is only rescuable with considerable effort which is definitely not worth it. Just do it again. Do wipe the disk, and I would just accept the recommended config unless you have goid reason not to)

Open ##5539274